Vessel segment 08 / 08 · Commercial & Workboat
Unheated compartments, bunks against bare steel
Where there is no insulated lining, the bunk sits against plating that is at sea temperature and drips when the compartment is warmed by bodies alone. Crews come off deck wet, and the accommodation has no drying capacity of its own.
Recommendation
20 mm is specified where condensation loads are heaviest and the structure is uninsulated. It holds the gap open under heavy-duty mattresses and keeps the underside clear of standing moisture.
Installation
Three steps, no tools
01
Lift the cushion
Remove the berth cushion and clear the board. No fasteners, no adhesive, nothing to drill.
02
Lay the fabric
Place the cut panel over the full berth area, running the length of the berth. Edges may be trimmed with scissors on board.
03
Replace and close
Set the cushion back on top. The gap works from the first night and stays open under sleeping load.
Request a sample or specification sheet
Response within 1 business day
Free samples for trade accounts
Worldwide shipping from Germany
OEKO-TEX Standard 100 certified
Contact
Tell us what you are fitting
Supplier
Pankoke & Hellmich GbR
Fosse Bredde 2533758 Schloß Holte-Stukenbrock
Germany
Response within 1 business day
Trade enquiries welcome
Trade enquiries welcome